View Single Post
Old Aug 29, 2009, 02:08 AM
NitroCharged is offline
Find More Posts by NitroCharged
Team30 Micro EDF
NitroCharged's Avatar
Adelaide, Australia
Joined Apr 2004
11,324 Posts
One thing I have noticed about the CO5 wire is that it is very brittle. Once you solder on your connector you need to put heatshrink over that and overlap it over the heatshrink of the output wires to hold it all together. Too much wobbling and the wires break.

The fact that all your motors are getting so hot sounds like you are over propping them. Use smaller props or bigger motors.
NitroCharged is offline Find More Posts by NitroCharged
Reply With Quote