Thread: Discussion SLOW-STICK X Build
View Single Post
Old Aug 16, 2009, 09:08 AM
jkarpy is offline
Find More Posts by jkarpy
jkarpy's Avatar
USA, FL, Orlando
Joined Aug 2006
2,027 Posts
Quote:
Originally Posted by Mr._Mulligan
OK, I tried searching for this info, but I can't find it. I just built the wing, and when I dry fitted to the stock wing saddles, the wing did not make contact with both saddles, because the center wing spar contacts the fuselage. I double checked all the joints, and it looks like I assembled the wing properly. What is going on? Should I post a photo?
Please read step 18 and see figure 17 and 18 of the manual. You need to trim the spar so it does not hit the fuselage. You only need to trim enough to clear the fuselage.

James
jkarpy is offline Find More Posts by jkarpy
RCG Plus Member
Reply With Quote