View Single Post
Old Sep 11, 2003, 07:43 PM
JVBAV8 is online now
Find More Posts by JVBAV8
Registered User
JVBAV8's Avatar
Honolulu Intl, Hawaii, United States
Joined Jun 2003
482 Posts
I was too
it's easy if you use a sharpened aluminum or brass tube
about 2-3mm od should be big enough for a little dubro flexible pushrod
use the middle of the inside bottom corner as the tube insertion point
use the middle of the outside top corner as a guide to rest the tube against
this aligns the tube straight down the middle of the wing and keeps the tube from wandering in depth
twist and go slowly - don't do the whole length all at once
all you can see on mine is a 1/4" hole inside the gear mount well and a 1/4" hole in the bay cut in the center of the wing
very clean install
just as long as your tunnel doesn't break the surface it will be invisible
JVBAV8 is online now Find More Posts by JVBAV8
Reply With Quote