Thread: New Product AXN Floater-Jet (aka Cloud Fly)
View Single Post
Old Aug 07, 2009, 02:24 AM
ajbaker is offline
Find More Posts by ajbaker
Argue for your limitations
ajbaker's Avatar
Lincoln, CA
Joined Oct 2006
8,430 Posts
Quote:
Originally Posted by jsec1992
Thanks Saucisse, AJ and Edgee400. I'll use the double-sided tape, packing tape and glue combo.

I'm still trying to figure out how the aileron servo cables run. I know how they go in the spar channel, connect to the Y-harness.... then what? there appears to be some kind of hole in the fuse where the two wing halves meet but that hole does not lead to the fuse where the RX will be. I know there's something about this somewhere in this thread (read through close to every posts here). Do I need to dig out a hole? Grateful for some help or pix here. The instruction leaflet is of little help, unfortunately.

Thanks!
Yes. you have to cut a little hole in the fuse where the notch in the wing is (for the "y" part of the cable). I glued my wings in. So, I cannot submit a picture which I would love to do. It actually is easier than it looks. Once you cut that little bitty hole in the fuse, you will say "Well, that was easy".
AJ
ajbaker is offline Find More Posts by ajbaker
Reply With Quote