View Single Post
Old Jul 17, 2009, 06:44 AM
rich smith is offline
Find More Posts by rich smith
7000mw of raw power!
rich smith's Avatar
New Hampshire (not the old one)
Joined Dec 2006
5,986 Posts
Quote:
Originally Posted by DanNsk
I have ATtiny12l , which is max 4mhz, can i use unmodified original code for this converter, or it needs to be changed, or unluckily i can not use that at all ?
The 4mhz spec is for use with very low voltage (1.8v). At 5v the chip runs at 8mhz and higher so there is no problem. In fact I've run them at 20mhz with xtl.

Also note this program is pretty much frequency indpendent. 8mhz will give about 300us gap which is close to real PPM.
rich smith is offline Find More Posts by rich smith
Reply With Quote