View Single Post
Old Jul 07, 2009, 10:51 PM
igotit is online now
Find More Posts by igotit
Registered User
United States, LA, Houma
Joined Jun 2008
1,706 Posts
sounds like your gear mesh is too tight...loosen the motor put a strip of paper between the gears then re-mesh and tighten the motor....roll the paper out and the mesh should be set!

but im leaning towards this one
it could be the set screw in your pinion hitting the gear too,are there any marks....like every 3/4 in on your main gear?

may have a dented tooth on the pinion too!
igotit is online now Find More Posts by igotit
Reply With Quote