Thread: Discussion 40" Dynamic Build Thread
View Single Post
Old Jul 07, 2009, 10:30 AM
joe manor is offline
Find More Posts by joe manor
Stay in it!!!!
Riverside, California, United States
Joined Aug 2004
5,061 Posts
Receiver Install

I take a drinking straw and shrink the antenna to one end and spiral wrap around until I get to the other end and add another piece of shrink tubing. This allows the antenna to stick out around 6" at the rear. I CA the shrink tubing to the side of the fuse in the front to keep it in place. Just a little so I can remove it if necessary. The receiver in this model will be run up front behind the battery but there is also room to slide a small receiver behind the elevator servo under the wing bolt area. This is done if you run a AA stick pack.
joe manor is offline Find More Posts by joe manor
Reply With Quote