Thread: Discussion 40" Dynamic Build Thread
View Single Post
Old Jul 07, 2009, 09:56 AM
joe manor is online now
Find More Posts by joe manor
Stay in it!!!!
Riverside, California, United States
Joined Aug 2004
5,061 Posts
Now For The Wing

I cut a hole in the wing big enough to slide both extensions through. I use gorilla CA to glue in the servos and horns. On this model I had to remove a small amount of material to get the servo to fit. This has been addressed and the next run should have slightly larger cutouts. The install goes the same as any other setup. Keep everything tight.
joe manor is online now Find More Posts by joe manor
Reply With Quote