View Single Post
Old Jun 18, 2009, 09:25 AM
mmormota is offline
Find More Posts by mmormota
Registered User
mmormota's Avatar
Budapest
Joined Jul 2003
2,606 Posts
Video
REmzibi OSD current sensor test

This is a test video of the diy current sensor for the Remzibi OSD.

The battery voltage, the current and the mAh is measured same time by the diy sensor and the Emeter.
Check the voltage, current and mAh (marked with just m as no mAh character in the table) in the bottom left of the screen and the corresponding values on the Emeter's screen.
(the gps is not locked, so no bother with any other data but these three in bottom left)

Remzibi: there is a possible firmware bug, did you observed the unknown unintended "9m" displayed for a few seconds above the voltage value?
mmormota is offline Find More Posts by mmormota
Reply With Quote