View Single Post
Old Jun 13, 2009, 03:48 PM
mrbrt is offline
Find More Posts by mrbrt
Registered User
Edmonton, Alberta
Joined Apr 2009
72 Posts
Thanks Kosmic for those accurate measurements

Im worried about that tab that the hirose connectors have, and it doesn't seem that the a-hd+'s have the same matching ones. The connector the webbie uses doesn't have it 100%, renato sent me pictures of those. I tried to make a breakout board before and ran into the issue where I had to shave those tabs off to make things fit. This could be a custom made connector (hirose and samtec both do it).

Ive caved and ordered this camera off ebay, trying to mess around with it without having one isn't working out.

Gussy, the connectors tvdude ordered have a different stacking height than yours. I think the only problem he had was the width not the height. Did you measure these out or is this a guess and check that you will be doing? I know the pcb's won't change because the footprint is identical, but I was still wondering.

-m
mrbrt is offline Find More Posts by mrbrt
Reply With Quote