View Single Post
Old Jun 04, 2009, 03:34 AM
GOK is offline
GOK
Find More Posts by GOK
GOK
Registered User
Turkey, Izmir
Joined Aug 2005
1,302 Posts
I do have some questions at this stage, and would really appreciate any feedback.

- The spinner backplate is out of balance and is costing me a few extra amps and 10-20 watts less power Is there a simple way to balance it?

- How do I get air flowing around the motor. The spinner and the backplate are like a wall up front of the motor. If I cut a few slashes in the front sides of the cowl (like in the below pic) would this create air current around the motor?

- While installing the stab, I messed up and it is slightly crooked. Actually it is not really crooked but a little off centered so I now have slightly more right stab according to the left side. This is clear in the below pic. Need I be overly worried about this? Had it been a foamie it would have flown even without a stab But I am not experienced with models this size

So these are some of the issues I am tackling at the moment, please feel free to offer advise

Cheers,

GOK
GOK is offline Find More Posts by GOK
Last edited by GOK; Jun 04, 2009 at 03:42 AM.
Reply With Quote