Thread: Discussion The AttoPilot project
View Single Post
Old May 25, 2009, 03:04 PM
Irv is offline
Find More Posts by Irv
AKA the"Old Flyer" KI6SPO
Irv's Avatar
Carlsbad, CA
Joined Aug 2004
104 Posts
The RC receiver is strapped to one side of the pylon and the AttoPilot strapped to the other. A tower was added for the XY sensor. The GPS antenna was stuck to the fuse at mid-tail, the MicroCard holder and Z sensor were stuck on the left side of the cockpit. The ESC was stuck on with Velcro.


The system was interconnected as described in the "manual". None of the leads were cut. All excess wires were bundled and slip tied. We used a lot of double sided rubber tape, Velcro, blue masking tape and some CA glue.
Irv is offline Find More Posts by Irv
Reply With Quote