Thread: Discussion Another new 2.4GHz system!
View Single Post
Old May 17, 2009, 11:34 AM
BlueFFF is offline
Find More Posts by BlueFFF
Up in smoke!
BlueFFF's Avatar
Greenville, TX
Joined Jun 2007
627 Posts
MoFl,

My RF module is the same as the first picture you posted (old version). I checked the TX and I do have 5V on pin 2 as shown in post 178, so perhaps the resistor is to avoid noise as you suggest. I double checked my cable again against the pinout for post 178 and looked at the connection labels on the circuit board and they all match up, so my cable is built right, but it lights up green instead of red when pluged into TX.

Thanks for the help,
BlueFFF
BlueFFF is offline Find More Posts by BlueFFF
Reply With Quote