Air Hog's F/A-18 Brushless twin mod with Vapor brick + DX6i-DX7 elevon mixing + Video
View Single Post
Apr 11, 2009
, 05:44 PM
Doing it in the Lateral Axis
USA, OH, Akron
Joined Dec 2006
AH BL Pusher F\A-18
Just got this together. I will post a video of it running here in a bit.
here we go..
AH Brushless Pusher Jet
(0 min 26 sec)
View all Images in thread
1 gram BL controller. The connectors were eliminated and wires are soldered direct to the circuit board.
I wired the BL ESC like a servo connection here. Orange=signal, Red +, Black -.
very simple setup.
I was getting a lot of glitching with my green dot brick, after reorientation of the antenna like this, much of the glitching was eliminated.
figuring out the motor placement.
This prop is a bit big.
This one is better.
All done and ready for test flight.
both stock motors.
AUW with a 130mah lipo.
weight of the plane less the lipo.
Last edited by modfly; Apr 12, 2009 at