View Single Post
Old Jul 22, 2003, 11:48 AM
Karl Bē is offline
Find More Posts by Karl Bē
29 rods from you in western WI
Karl Bē's Avatar
Joined Jan 2003
4,885 Posts
Melf, I was concerned with the wing joiner, and I did notice it loosening a bit. I found the nut wasn't holding, so I replaced it with a nylon-insert type locknut.

I considered adding two more bolts near the fuse sides to lock it down, but figured that what I'd gain in leverage I'd lose in material strength. What I did instead for peace of mind was to wrap a small zip tie around each end of the spar sandwich near the fuse sides.

Any pictures yet?

Karl
Karl Bē is offline Find More Posts by Karl Bē
Reply With Quote