View Single Post
Old Jan 27, 2009, 09:49 PM
_Peter is online now
Find More Posts by _Peter
Gotta Luv Gasser Helis..
_Peter's Avatar
Gold Coast, Qld , Australia
Joined Apr 2006
340 Posts
Found this ..

All Jazz speed controls up to 18 cells have a switch mode BEC included. The types
for higher voltage have no BEC. The continuos current of the BEC is 1.5A, the short
time current for 10sec. is 2.5V.
In opposite to usual BEC-systems the capacity of the BEC is mostly independent on
the input voltage. This allows the usage up to 18 cells (24V). Additionally the BEC
distinguishes due to a high suppression of interference. A use of this speed controls
without BEC is possible by pulling the red wire of the receiver cable out of the
connector or by ripping this cable.
The use of a 4 cells receiver battery pack is recommended (see safety information).
The pack is connected parallel to the speed control into a free place of the receiver.

Sounds like a waste of effort even trying to use the BEC.....
_Peter is online now Find More Posts by _Peter
Reply With Quote