View Single Post
Old Jan 27, 2009, 08:46 PM
JimDrew is offline
Find More Posts by JimDrew
Xtreme Power Systems
Lake Havasu, AZ
Joined Jun 2005
16,941 Posts
Well, that could be the issue. Most regulators do not function properly when more than 12 volts are used as the input voltage (Castle's 10A BEC is a good example of this).

Try just a straight 4 cell pack without the servos plugged into. Start plugging the servos in one at a time and see if you ever get a orange LED. If you do, then either the servo is bad or the 4 cell is not big enough for the load capacity.
JimDrew is offline Find More Posts by JimDrew
RCG Plus Member
Reply With Quote