View Single Post
Old Jan 22, 2009, 09:06 AM
everydayflyer is offline
Find More Posts by everydayflyer
Southern Pride
everydayflyer's Avatar
Haralson County GA. USA
Joined Oct 2004
34,852 Posts
I am using default 5 Mv peak,0.8V per cell cut off , Normal 4A charge , 2Amp. discharge with 5 min. dwell between charge and discharge.

Contacts to the pack is crude but works. 12 ga. super flex with heavy tinned ends, rubber band around contact area as tight as I can get it and leads inserted under it.

I need to come up with an plastic clamp with contacts and leads but the make shift setup is working fine for now.

I also need to take a pack or two that has been cycled and run some serious higher amp. discharges to simulated drill motor ,cut of saw etc. useage. I figure at the very least these packs will sever well with the flash lights as they have a low amp. requirement.

Charles
everydayflyer is offline Find More Posts by everydayflyer
Last edited by everydayflyer; Jan 22, 2009 at 01:48 PM.
Reply With Quote