View Single Post
Old Jan 12, 2009, 12:55 PM
Hepdog is offline
Find More Posts by Hepdog
Registered Plan-a-holic
Hepdog's Avatar
Stonewall, MB, Can
Joined Jul 2004
2,889 Posts
Quote:
Originally Posted by dag214
I will check something tonight. The mid-shaft bearing fits the shaft well, but does not need to be pressed on. I wonder if I am just a little to loose and the shaft at RPM is moving just a little. I have checked the bearings and they are not binding or loose, but that shaft may be just a 10,000th off.

Thanks, DAG
Thinking outside the box, you know how on 2 peice industrual drive shafts they mount the steady bearing in hard rubber to isolate inevitable vibrations??? Maybe the mid mount bearing should not be as firmly mounted? Of course that could cause bigger issues than it solves.

At any rate test the crap out of what you have and fly it. At our RC duty cycles it probably will never be a problem.
Hepdog is offline Find More Posts by Hepdog
Reply With Quote