Originally Posted by fxstbi
The Yak looks good! Any chance you could put up plans that are not tiled? I'm an engineer and have access to plotters that can print them full size. Thanks for a great design.
Here you go.
There will be few minor revisions to the plans but this should be fine for most builders.
The planned revisions are:
1) Reverse the aileron servo cutout so that the wires come out the back
2) Mark the cg location
3) Mark the recommended tail servo, esc and battery locations.
Right now the battery is just a bit forward of the cg. I like to have the battery right at the cg on my planes, this way I can use different size batteries with no trim changes.