Thread: Build Log Wicked powered SR-71
View Single Post
Old Dec 05, 2008, 12:32 AM
Knife Liddle is offline
Find More Posts by Knife Liddle
Lee Liddle
Knife Liddle's Avatar
Carrollton, Tx
Joined Dec 2006
9,483 Posts
CG Location

Don, just a heads up. Double check you CG location. My instructions say 78mm back from the front edge of the motor pods.

The small marks in the wheel well area are 5/8" farther back than that. The small marks DO NOT mark the CG location on my model.

On mine the measured CG is about 1/16" behind the back edge of the rx compartment.

When you get a chance check this measurment on yours. That should tell if they are out of the same mold or not.

Planning to fly my pusher prop version tomorrow.
Knife Liddle is offline Find More Posts by Knife Liddle
Reply With Quote