Thread: Discussion Micro3DX
View Single Post
Old Nov 20, 2008, 06:31 PM
jkarpy is offline
Find More Posts by jkarpy
jkarpy's Avatar
USA, FL, Orlando
Joined Aug 2006
2,027 Posts
Quote:
Originally Posted by mkeigwin
So far this is what i have done . i waited to install the hatch in step one until after i glued the formers in . that way i did not get them wrong.
Mike, the washer I included in the beta kit is stainless so it will not work with the hatch magnet. You will need to replace it with a steel washer.
jkarpy is offline Find More Posts by jkarpy
RCG Plus Member
Reply With Quote