Thread: Mini-Review New CopterX 3D CX450 Black Angel
View Single Post
Old Nov 18, 2008, 12:23 AM
nyc863 is offline
Find More Posts by nyc863
Registered User
Joined Nov 2008
605 Posts
I used this
http://www.rcgroups.com/forums/showthread.php?t=552714

for my 401 setup.

With the pitch slider in mid-throw, the tail
blades were neutral (0 degrees) rather than having some positive
pitch built in.. pretty much the 401 was set to 100% of travel using
the futaba servo wheel after I shifted the servo so the slider was
@ center.

Then in non-heading hold mode about 10-15 clicks of subtrim stops the
piro, so the 401 has memorized that as neutral in its AVCS (hh) mode.

oh and when I discovered my belt twist problem I tried to undo a tail
bolt using the included allen key but it was so tight, it stripped the head
I'm not sure how I am going to get that bolt off if I need a new belt ...
I guess the copterX bolts are not exactly hardened steel. Replacing many with quality hex head machine screws might be the right thing at some
point.
nyc863 is offline Find More Posts by nyc863
Reply With Quote