Thread: Mini-Review New CopterX 3D CX450 Black Angel
View Single Post
Old Nov 17, 2008, 08:35 PM
Gino CP is offline
Find More Posts by Gino CP
Team Mulikow
Gino CP's Avatar
Manila, Philippines
Joined Oct 2006
9,564 Posts
No manual yet. To mount the balls on the servo arms, make a tap form an extra bolt of same size as ball studs. Then cut notch on tip to have a sharp edge. Then taper. I used a DRemel cutoff wheel. Then I clamped the bolt on locking pliers. After I tapped the servo horns, installation was easy.
Gino CP is offline Find More Posts by Gino CP
Reply With Quote