Thread: Discussion New Project = new problems !!
View Single Post
Old Oct 23, 2008, 11:36 AM
thorsail is offline
Find More Posts by thorsail
Registered User
thorsail's Avatar
Chicago , Illinois
Joined Jul 2008
1,030 Posts
Hi Dan
Is this running a forward only esc ? ( NO reverse ? ) If so , this may help , idea
wise... our guys make dumb-simple hulls to put buoys out for races - a small servo
with 2 sided horn is used . the idea is , push the TX stick up and the servo turns and
one side of the horn pushes against a switch which activates the motor . so now you
are where you want to be , pull the TX stick down and the servo turns the other way
and on our boats , it moves a little rod that is holding the buoy weight at the
transom , pin moves , weight drops . in your case , a line could lead to something
as simple a a cotter pin that hold yor ramp door closed , servo moves , pins pulls
out of hole and bait slides off the ramp. the switch for the motor is just a micro-
switch , only a little pressure is needed to send power to the motor ...
OK , now I'll sit back and wait for the correct way to do this by guys that really
know about this stuff .... lol

Allan
Chicago
thorsail is offline Find More Posts by thorsail
Reply With Quote