View Single Post
Old Sep 11, 2008, 05:59 AM
davereap is online now
Find More Posts by davereap
Registered User
davereap's Avatar
Ashford. Kent. England
Joined Feb 2005
7,514 Posts
Any one building in depron..ive just found this craft tool that has the correct temperature for easy bending of depron

http://www.artdiscount.co.uk/acatalo...Craft_Gun.html

Ive incorperated a bending bar onto my testing board to make nice straight bends...It does a nice job with no damage to the depron.
It would save time in getting the tips up at the correct angle...slip the depron into the slot. use the gun and bend either around the rod or around the wood base's edge

there are two bends in the 1st depron section shown, bent around the rod for a gentler bend, rather than along the wood 2nd pic which gives a sharp bend
davereap is online now Find More Posts by davereap
Last edited by davereap; Sep 11, 2008 at 06:21 AM.
Reply With Quote