View Single Post
Old Sep 10, 2008, 10:09 PM
denial15 is offline
Find More Posts by denial15
denial15's Avatar
United States, UT, Orem
Joined Aug 2005
3,886 Posts
Originally Posted by gtfreeflyer
Was the noise coming from the prop, motor or ESC? It was barely audible and did not remain during the full, full throttle test. Suggestions welcomed...

I was looking at the HC website and saw this about the esc.

"WARNING: For some large motors, you must use ''High'' timing mode. Failure to do so will result in a burnt esc."

How is your timing set for the ESC? It may, or may not be the problem, but at least it's a start.

Also, the information on the 100 amp ESC said it was only good up to 6 cells. Do you think it will be able to handle the two extra cells if you keep the amps low enough?
denial15 is offline Find More Posts by denial15
Reply With Quote