View Single Post
Old Jun 08, 2003, 12:49 AM
TomL is offline
Find More Posts by TomL
Registered User
Joined Aug 2002
9 Posts
All the surfaces are free, as I said the plane has been flying fine for 2 months. The surfaces will function fine until you start moving all of them at once. While moving them all at the same time, and after about 5 seconds you can see them slow down then they will get to a point where they are moving so little that it looks as if you were to have a flight pack battery that the battery would be going dead.
I can also feel a component getting warm(real warm not to hot to touch) in the speed control under the heat shrink.

I think the voltage reg is slowly failing

Tom
TomL is offline Find More Posts by TomL
Reply With Quote