View Single Post
Old Jun 07, 2003, 07:10 PM
TomL is offline
Find More Posts by TomL
Registered User
Joined Aug 2002
9 Posts
Brushless speed control problem

The speed control that I am using with my Hacker C40 is not working correctly. It is a Jetti speed control that was provided with C40 when I bought the package.
The speed control works the motor fine, but after a slight amount of time working the control surfaces, it appears that powe that is going to the servos is depleted (servos work slowly, and eventually stop), but the motor control is still ok.
It almost seems like the voltage regulator is gong bad, if you stop working all the surfaces for a few seconds that surfaces will work ok, then fail slowly.
My battery is fully charged, and the speed control has been working fine for about 2 months.

Any ideas ?

Thanks
Tom
TomL is offline Find More Posts by TomL
Reply With Quote