View Single Post
Old Aug 09, 2008, 05:10 AM
thomasscherrer is offline
Find More Posts by thomasscherrer
Registered User
thomasscherrer's Avatar
Danmark, Hovedstaden, Ballerup
Joined May 2007
3,260 Posts
2.8V is fine with me, as long as it is 2.8V over GND ?
and not floating some where 3-5V ?
my PPM input signal goes into a 3.3V microcontroller, after a pull up resistor, 100k
and a series resistor 270 ohm, and a 3.3V zener protection diode.
so I guess a 2.8V PPM signal will work just fine with me.
lets see a scope picture ?
try to load the signal with 100k to gnd and to + battery voltage ?
to indicate if the signal is super high impedance and can maybe not handle any load ?
thomasscherrer is offline Find More Posts by thomasscherrer
Reply With Quote