View Single Post
Old Jul 27, 2008, 08:58 PM
pval3 is offline
Find More Posts by pval3
Registered User
pval3's Avatar
raleigh, NC usa
Joined Aug 2001
1,993 Posts
biggun s

My building area is 72" long. You can get an idea of the size of the area needed to work on this airplane.

Although the belt sander does take up some area at the end, the wing takes up a good section of that table!

It is a big bird with a nice high aspect ratio appeal!

I laid the cores out and laid the leading edges into the front of the beds to get an idea of how they fit.

the fit was dead on and the cutting matched dead on too top and bottom.

Jeff does such a nice job on the cutting. . . .makes this so easy to work.
pval3 is offline Find More Posts by pval3
Reply With Quote