Boys I ran across this thread while surfing RC Groups and boy am I hooked!!
I downloaded the plans (thanks so much!!)
and am shortly about to start cutting out the parts. I just have a couple of questions.
Do you think it's OK to build the body/wing out of 6mm and the other parts out of 3mm? I have some 6mm spars so I would like to take advantage of the 6mm foam. Or should I just use one or the other? I plan to use the same motor from hobby city (I have 2) and a 700 Mah li-poly 2 C. I finally found the CG so I'm OK there. What are the throws set to? I also assume I will need mixing ( I have a Futaba 7C computer radio). I am the VP of a club in Southern NJ and I am going to take her to the meeting this month.
I would like the Guys in the club to consider your design for a one of a kind design contest.
I hope you don't mind Adam.
I look forward to your reply.
Thanks ahead of time Guys.