Thread: Download RC-USB Joystick Files
View Single Post
Old Jun 27, 2008, 01:45 AM
alessio70 is offline
Find More Posts by alessio70
Registered User
alessio70's Avatar
Italy, Tuscany, Florence
Joined Feb 2005
82 Posts
Originally Posted by Jappa_Indy
I built this fine device however I can only get it to function with the NG2 4 axes code.

A&A code for 8 axes only returns "Unknown Device"

quite strange.... anyway the difference between 4 axes and 8 axes is that 8 axes is a full speed usb device.... (then requires at least USB 1.1) while 4 axes is a low speed usb device.... what kind of hardware have you build? for 8 axes check you have not mounted the resistor between VUSB and D-

check also the cable... if you used a very old cable.... anyway if you can try to change it...

alessio70 is offline Find More Posts by alessio70
Reply With Quote