View Single Post
Old Jun 22, 2008, 08:54 PM
junsi is offline
Find More Posts by junsi
iCharger
junsi's Avatar
Joined Mar 2007
1,091 Posts
Quote:
Originally Posted by Julez
Well, I just had a closer look at the manual, and I noticed that the motor break-in feature is almost the same as the foam cutting feature.
Not as convenient, but the following should work:

Just connect a cutting wire instead of the motor, set the amp to 4A, and slowly work your way up at the voltage setting, until you have the desired wire temperature.
The max. voltage of 15V would limit the wire length to 0.6m, though, at least with the type of wire I use.

Junsi, concerning the manual:
At the program flow chart, how about putting little numbers under each display image, which refer to the page number of the manual, where this feature is described in detail?

For example, put a "18" under the PB charge display images, so one would see directly, that one has to go to page 18 in the manual to find the explanations.

Cheers,

Julez
Hello Julez,
Thanks!
As for the putting little numbers under each display image , We just misundestood your meaning , we will add the page number to the under images of flow chart.Thanks!
We really appreciate this valuable idea, it's really a convenient way.

Thanks,
Junsi
junsi is offline Find More Posts by junsi
Last edited by junsi; Jun 22, 2008 at 09:25 PM.
Reply With Quote