RC Groups

RC Groups
    Slope
        DSing 2m Carbon Blade, Vtail Suggestions

#1 paulywood Aug 18, 2005 01:39 PM

DSing 2m Carbon Blade, Vtail Suggestions
 
I have a new 2m Carbon Blade, That I'm putting together for just DSing.
Is that single screw going to hold that Vtail in place?, or should I do some other kind of hold down?
Any 2m blade DS'ers out there?
Thanks, Pauly.

#2 KingOfTheHill Aug 18, 2005 01:44 PM

dab of goop!!!!!!!!!!!!!!!!!!!!!!!!!

TRUST ME a DAB of goop and your safe and sound.... and a little bit of toulene or xylene dripped on it can take it off later if you need to make repairs or ship

JOe

#3 paulywood Aug 18, 2005 01:51 PM

I was thinking of that, but I was seeing what other guys are doing also.
Thanks for reasuring me. Pauly.

#4 Bill L Aug 18, 2005 01:51 PM

I drilled and re tapped the screw, new size was 6/32, used goop to keep it in place then added a band of 2oz cloth on both sides of the tail, make sure you fill in the void on the leading edge of the elevator with a bit of epoxy, this will add ridgitity to the surface itself, mine were pretty flexy, some have a big enough gap for a small aluminim tube to be epoxied in

good luck

B

keep it under 210 :)

#5 aneigher24 Aug 18, 2005 04:57 PM

My screw began to loosen up a bit over time untill i had a secent wiggle, what i did was do all my aligning double check tripple check then mark then epoxy with microballons to glue it in ther good...then 40oople:)check youre measurements for incidence..etc and let it set,

Make sure to check for proper c.g after
@lex


All times are GMT -5. The time now is 05:43 AM.