RC Groups

RC Groups
    Flight Accessories
        Help! eagle tree guardian

#1 bushpilot05 Feb 05, 2013 06:30 PM

eagle tree guardian
 
I installed and tested by moving on all axis,the control surfaces only move a small amount.Gains are all the way up. Control surf. move normally when using sticks.I am using dx5,but recently purchased dx7. could it have something to do with transmitter? receiver is 6 channel.

#2 moto mike Feb 22, 2013 11:37 AM

I haven't used the eagle tree but did use another 3 axis gyro the orange x. And control surface movements were small. I think that it reacts quickly enough that small inputs are all that is needed. If you have too large movements, the danger of airframe shaking oscillations result.

I think the recommendations are that you start with just perceptable movement when you twist it about by hand.


All times are GMT -5. The time now is 03:02 AM.