RC Groups

RC Groups
    Multirotor Talk
        Discussion New KK Board Guard Design

#1 stiflerzx Dec 07, 2012 09:34 PM

New KK Board Guard Design
 
4 Attachment(s)
Good day all! :)

I've been attempting to create a KK board guard that will allow for some wire management while also protecting the board itself from the damage of a crash. This is a prototype so I'm open to all suggestions.

I designed this to protect the KK2.0 Multi-rotor LCD Flight Control Board. Although it could be adapted for various types. It also allows for wraping wiring around the end.

Total Weight: 20g
Total Height: 28.5mm


This seems to be a good balance between strength, style and weight.
What do you all think?

#2 CH33ZEBURG3R Dec 08, 2012 12:53 AM

1 Attachment(s)
Well it's a good start but i'm not too keen on the pieces that would hold the wiring, what i would prefer is having two pieces of the stuff it's made of and have them curved and crossing at the top, that way it would offer even more protection.

Iv'e tried to show in this photo, but i only did it quickly, i hope you get the idea.
Attachment 5357561


All times are GMT -5. The time now is 02:18 PM.