RC Groups

RC Groups
    Beginner Training Area (Heli-Electric)
        Discussion Questions on my V911

#1 Bob6831 Nov 29, 2012 01:01 PM

Questions on my V911
 
Hi.
I have a V911 where I broke a wire (from the main motor) off from the printed circuit board. My problem is that it took a piece of the land off too and I don't know where I can solder it to. I guess I need a circuit diagram. Any help?

Also, I got another V911 and it just wants to go backwards. I adjusted the legs that control this..... but still does. Note that I even went so far as to take the inner parts of the V911 with the broken wire (including swash plate and upper blades) and put that on this one and still have the backwards problem.
Any suggestions?
Thx.

#2 Hajile Nov 29, 2012 05:55 PM

Check swashplate if it had popped out.

#3 Bob6831 Nov 30, 2012 12:11 AM

As I mentioned, I had swapped parts - including the swash plate - from 1 heli to the other and was no difference.


All times are GMT -5. The time now is 04:59 AM.