RC Groups

RC Groups
    New Forum Requests
        Help! New 50cc Yak. anyone know how I can get rid of my radio interferance???

#1 Sahrens Nov 20, 2012 04:55 AM

New 50cc Yak. anyone know how I can get rid of my radio interferance???
 
Just got my first gasser. It's one from a guy in the club he flew it 3 times fine. I get it set up and running and I can't seem to stop the interferance to my servos. It's a hangar 9 Yak-54, got all Hi-Tec 625mg, 50cc Fuji engine electronic ign. I twisted all the servo wires, even ran shielded twisted extensions. NO LUCK and it gets worse as soon as the engine gets warmed up. I managed to get one flight in before I noticed how bad it was as the temp came up. Im an electric 3d pilot so im kinda stumpped. It didn't do it with the wings disconnected and ground run perfect. Im very frustrated I am dying to burn some fuel and make some noise.

#2 rcairboater Nov 27, 2012 08:51 PM

Try posting here. These guys know engines.

http://www.rcgroups.com/engines-140/

-Gary


All times are GMT -5. The time now is 06:24 AM.