RC Groups

RC Groups
    F3A Pattern
        Discussion Rudd-Ail mix

#1 KenChoo Nov 19, 2012 09:09 AM

Rudd-Ail mix
 
Hi everyone, I have rud-ail mix (same dir, i.e. left rud - left ail) and during slow roll I find the roll rate speeds up in the second half because of the application of different rudder in the first vs second half...that is, rudder in first half has ail from the mix opposite to the roll direction so the roll is slower, then after that opposite rudder has ail in the same direction as the roll rate speeds up.

Any suggestions to manage that? Or is it just varying ail input?

#2 johncoulouris Nov 19, 2012 03:07 PM

Quote:

Originally Posted by KenChoo (Post 23307091)
Hi everyone, I have rud-ail mix (same dir, i.e. left rud - left ail) and during slow roll I find the roll rate speeds up in the second half because of the application of different rudder in the first vs second half...that is, rudder in first half has ail from the mix opposite to the roll direction so the roll is slower, then after that opposite rudder has ail in the same direction as the roll rate speeds up.

Any suggestions to manage that? Or is it just varying ail input?

Personally, I use the stick position switch on my JR XG8 (logic switch on futaba) to turn off the mix when using very little aileron.


All times are GMT -5. The time now is 12:34 PM.