RC Groups

RC Groups
    CAD/CAM
        Discussion GMFC problems

#1 jcyr1 Oct 31, 2012 09:13 PM

GMFC problems
 
Hi all,
Am having troubles using the "trim after cutting"......
Everything is fine cutting with "no trimming", "trim only" but
when using "trim after cutting" it goes "willy-nilly". The trim cuts are
way out of where they should be. Also the cuts are way out
of where they should be. It's like it forgets where the sweep is.
Has anyone seen this???
It's been a while since I've cut anything, I get "melted foam" when
cutting. Especially around L.E.. Can't remember if I add heat or slow
down.By the way I'm using ver 3.89.15.
John


All times are GMT -5. The time now is 07:32 PM.