RC Groups

RC Groups
    Foamies (Kits)
        Discussion Using a cnc mtor mount w/ bixler

#1 trinium42 Oct 11, 2012 10:24 PM

Using a cnc mtor mount w/ bixler
 
I recently got my bixler, and the first thing that I bought for it was a cnc motor amount that in my opinion is much better then stock. I also dropped the stock motor in favor of a turnigy 2217 1050kv, and I put on a prop recommended to me by the guy who I got the mount from.
https://lh3.googleusercontent.com/-X...2020.59.26.jpg

https://lh6.googleusercontent.com/-d...2020.59.51.jpg

As you can see, the round end is glued into the bixler, and then you mount the motor to the other piece which can be mounted at stock. or higher depending on the motor and the prop. as It is my 8" prop just barely clears.
https://lh4.googleusercontent.com/-v...2021.01.27.jpg

As of yet Im still waiting for my APM and electronics chasis to glue the fuze together. But Im starting to wonder if I will have problems flying with this config vs stock. what do you guys think?

#2 KCinNC Oct 11, 2012 10:33 PM

dude, you might be on to something ! i've been looking at one of these planes myself. any upgrades are good to go !

i'm subscribed....let's here it

#3 trinium42 Oct 12, 2012 10:44 PM

Just ordered my electronics gearpod from Rocketma1092. (Shipped the next day!) Also today I recieved my APM2.5 Airspeed sensor, GPS and some other goodies. When everything gets here it will be time to put this baby together!


All times are GMT -5. The time now is 08:03 PM.