RC Groups

RC Groups
    Scratchbuilt EDFs
        Cool 80mm Mako sportjet design

#1 MustangAce17 Oct 09, 2012 10:46 PM

80mm Mako sportjet design
 
3 Attachment(s)
this is something I've been working on for a few days, on and off. It's getting a Eflite 80mm fan on 7s and I hope to have it rtf at Zeff in a few weeks. Not sure what wings will be used yet but I did the drawing awhile back with retracts as the intention. More to come.

#2 Waltjg Oct 10, 2012 06:41 AM

Looks good so far.. Keep the project going it should turn out good and I'm sure you will put plenty of power in it :D. Thinking about what I want to build next as I would like to put retracts in it... W

#3 MustangAce17 Oct 10, 2012 10:43 AM

Thanks Walt, I plan to finish this one soon, and ya something around 2000 watts :D

#4 Kevin Cox Oct 10, 2012 06:16 PM

Cool!
Be warned that looking at the placement of the fan, wing location, wing plan form and planned battery size (under the canopy). You might have a hard time balancing the model, looks like it could be nose heavy.

#5 MustangAce17 Oct 10, 2012 07:10 PM

Kevin, thanks for that, my designs tend to be more fantasized than realistic so I will make changes if need be. I'm going to work on it again here in a few minutes. More pics to come, it will make more sense very soon. Thanks for the interest:)

#6 MustangAce17 Oct 11, 2012 12:01 AM

2 Attachment(s)
more progress, retracts mapped out and modified struts for angle,tail section complete and ducts,wings,and tail feathers started. Also re profiled the canopy, I like it much better now

#7 Waltjg Oct 19, 2012 06:33 PM

Looking good Kyle! W

#8 nadine Oct 19, 2012 11:43 PM

Where to find 3 views for this plane!?I try with gogo:D,but poor stuff:cool:
Cheers ...

#9 MustangAce17 Oct 30, 2012 09:57 AM

Made more progress, one wing panel is almost done and airframe parts have had 1/2 ounce glass applied, pics to come

#10 MustangAce17 Jan 09, 2013 07:55 PM

The wings and intakes/retracts didnt turn out how i planned so this project is on hold, have another design to work on for 90mm


All times are GMT -5. The time now is 03:01 AM.