RC Groups

RC Groups
    Painting and Finishing Tips
        Discussion New Stuff lam film

#1 cityevader Oct 09, 2012 02:40 PM

New Stuff lam film
 
I've used this on my Slope Monkey wing. It stick great to balsa, but not so much on EPP. There are lots of air pockets where it didn't bond. I was working from the middle outwards FWIW.

The instructions I first read were to keep the temp at 220, but I found this didn't melt the adhesive backing adequately. 300 worked better.

Could it possibly too hot and affect the EPP itself preventing a good bond?

I thought I read once somebody used 3M77 on the EPP first and then applied the New Stuff...but can't find where I read it. Would this be a realistic technique?


All times are GMT -5. The time now is 04:14 AM.