RC Groups

RC Groups
    Xtreme Power Systems
        Question Advice on working with XDP

#1 FlyingW Oct 02, 2012 12:11 PM

Advice on working with XDP
 
I needed to run the XDP program to change the channel mapping on some nano receivers. I had a perceived problem where I thought the XDP program could not see the XDP device.

I have Windows 7. Installed the latest program from XPS (as Administrator) and the drivers installed successfully. Even tried a new usb cable.

Turns out the XDP program was looking for the actual receiver - not the XDP device! It works just fine.

I felt a little foolish, but was relieved to be able to make progress on the project.

Paul

#2 FlyingW Oct 02, 2012 02:31 PM

Got it working as described above.


All times are GMT -5. The time now is 04:37 AM.