RC Groups

RC Groups
    Scratchbuilt Multirotors
        Discussion How and what ESC settings do you put on yours?

#1 prodriverex Sep 29, 2012 11:23 PM

How and what ESC settings do you put on yours?
 
Brakes, ON or OFF?
Switching Freq? 8 or 16kHz? My Turnigy Trust 55A has this but i never seen this in other ESC.

#2 Steveis Sep 30, 2012 12:31 PM

Brake off
NiMH battery
16kHz
Start mode normal
Cut off soft

#3 NtiT Sep 30, 2012 01:53 PM

I set my switching freq. to high (22-30) and it works well.

#4 dutchcommando Sep 30, 2012 04:42 PM

the list as Stevis said..

but nowadays i just flash them to simonK firmware when i get them..
nothing more to do anymore with settings.. just throttle cali and use and abuse! ;)

#5 2400RDR Sep 30, 2012 06:32 PM

I flash mine with SimonK too. No muss no fuss. They work better for multirotors too when flashed.

#6 prodriverex Sep 30, 2012 06:53 PM

Not all can flash.. at least my Trust 55 is not on the list.. I forgot to take a look at the circuit when I remove one of the shrink. Now that I put it back with bullets soldered, I dun have a bigger shrink to pass through that size now if I cut open.

There is this timing setting: auto, 7deg for multi poles motor, and 30deg for out runner! My motor is both multi and OR! I opt for 7deg since its a disc shape with 24poles.

Yes freq I choose 16khz.

#7 NtiT Sep 30, 2012 08:50 PM

7 is for in runners, with usually less than 5 poles. 30 is for more poles, like almost all outrunners. Choose 30 definately for a motor with 24 poles.

#8 prodriverex Sep 30, 2012 09:28 PM

Ok will switch to that.
Just another elementary question on the Tx. I know this is a multi rotor heli setup, but we have to chose Acro mode as model type?

#9 NtiT Sep 30, 2012 10:33 PM

Yep. The FC uses normal THR/RUD/AIL/ELE input instead of anything pre-mixed for helicopters.


All times are GMT -5. The time now is 01:29 PM.