RC Groups

RC Groups
        Discussion changing mode on a Futaba T6J to sheet on left ?

#1 glouis Jun 15, 2012 02:11 AM

changing mode on a Futaba T6J to sheet on left ?
Hi, do any of you know if it is possible to change the mode on a Futaba T6J ? One tx I am looking to buy has the "throttle" on the right but I am used to sheet in-out with my left hand. Is it possible to change that mode or is it set by the manufacturer ?


#2 skipper67 Jun 16, 2012 08:55 PM

Just plug your rudder servo into the 3rd channel on your receiver. That will make the steering on the left stick.:):)

#3 chilisoling50 Jun 17, 2012 10:37 AM

If I am not wrong the set up you have now is called Mode 1 with throttle on the right .
What I have done to change mine to mode 2 is by opening the back of the cover and remove the spring from the left side and put it back on the right side. This way the rudder will still have the spring actions( return to neural position after you push it once) and while the left stick is just sliding up and down.( becarefull which spring to remove_, you need to remove the spring that dictates the up and down motion of the stick ( for sheets pull in and out ) not the other one which control the horizontal motion one.
You will see a piece of ratchet at the right side now above the stick drum .
Just put it on the left side so it will do the same as before on the right side before).
If there is no Futaba ratchet there already. Yo can make one or buy it from Tower Hobby.
Good luck.. I do the same for all my Hitec Radio transmitter.

All times are GMT -5. The time now is 01:37 AM.