RC Groups

RC Groups
    Beginner Training Area (Heli-Electric)
        Discussion Help with CX-CT6c

#1 Maverick888 Apr 14, 2012 07:57 PM

Help with CX-CT6c
 
Hi Guys,
I'm new to RC helicopter, I have copterx 450me-rtf, I accidentaly reset my transmitter (CX-CT6C-mode1) to factory setting, now the motor is running even the throttle is at minimum level. Do you know where i can download the baseline config for this transmitter. Also, is it possible for this modem to convert to Mode2? Thank you.

#2 Essex2visuvesi Apr 15, 2012 04:13 AM

Have you tried asking the seller?

#3 Ribble Apr 15, 2012 02:17 PM

2 Attachment(s)
FS-CT6B transmitter for 450V2

These are likely close to what you want.

#4 Maverick888 Apr 16, 2012 07:27 AM

Thank you. I will use this as my baseline config.

#5 Melnic Apr 19, 2012 08:35 AM

blueray 450 baseline will work bu you may have to play with servo reversing and swash pmix polarity
http://www.mycoolheli.com/t6config.html

#6 XtalHunt Dec 06, 2012 01:10 PM

...

#7 Yoneal Mar 19, 2014 08:33 PM

Quote:

Originally Posted by Melnic (Post 21375484)
blueray 450 baseline will work bu you may have to play with servo reversing and swash pmix polarity
http://www.mycoolheli.com/t6config.html

Hi, I got this transmitter, mode 2.
But I choose mode 1 in the stick mode menu, The throttle is 100% when the stick is all the way down.

I tried to reverse anything possible but no way.

So now, instead of seting my pitch curve : 40,45,50,75,100 I must set to 100,75,50,45,40 !!!!!!!!!!

I don't want to try hovering with this setting.

Please help

#8 holtneil Mar 20, 2014 01:50 PM

Hi mate that copterx transmitter has i file called recovery this should hold all the factroy settings for transmitter and models here is a link for the manual start at page 10 the transmitter can run all modes 1 to 4
http://www.ky-model.com/copterx/cx-ct6c_manual.pdf

#9 Yoneal Mar 20, 2014 08:20 PM

Quote:

Originally Posted by holtneil (Post 27844294)
Hi mate that copterx transmitter has i file called recovery this should hold all the factroy settings for transmitter and models here is a link for the manual start at page 10 the transmitter can run all modes 1 to 4
http://www.ky-model.com/copterx/cx-ct6c_manual.pdf

Hi, thanks for your answer, and sorry for my english, I'm french.

I tried anything possible.

Everything works great in mode 2.

But when I choose mode I, low stick will give me 100 and high stick will give me 0.

Of course I tried the menu CH. REV and any other possible thing.

Once again, everything is ok in mode 2.

I'm about to buy a new transmitter.

But what's the point to make it possible to change mode, when it's impossible to set it up right..

There should be a way....

#10 jueangshiluo Mar 21, 2014 05:23 AM

the point to make it possible to change mode, when it's impossible to set it up righthttp://goo.gl/XxTL47


All times are GMT -5. The time now is 08:42 AM.