RC Groups

RC Groups
    Hoverfly Technologies
        Help! The yaw not work in my HFP

#1 copteryx Apr 05, 2012 07:36 PM

The yaw not work in my HFP

I have a HFP green board and I was happy with the perfomance but sice 1 month ago the yaw stop working, I do all the test in the hoverfly setup software and everything its ok but when I try to fly it, the quad spins in CW direcction, I mount the board in a Y6 with robbe motors, turnigy push esc, 10x45" and 12x45" props, I try in my hexa DJI f550 flat with the same motors with 10x45" and the last try in a xaircraft X650V 4X with avroto motors an 1147 props, I upgrade an downgrade the firmware, all the setups same problem no yaw response, I use the same Tx (Ftaba 8fg super) with my WK-M and my KKblack board with out any issue, Im very dissapointed, any idea whats wrong?

Thank you


#2 photronix Apr 05, 2012 09:11 PM

It is usually either....you need to re-calibrate the throttle on the ESCs, mechanical misalignment (motors have to be straight up and down), Props not rotating in correct direction, Gyro failure (use the Setup Client to test this), motors not connected correctly to the PRO. Check this last one since there may be a difference in setup on the other controllers.

#3 copteryx Apr 06, 2012 02:53 PM

Ok I will recheck

All times are GMT -5. The time now is 09:00 AM.