RC Groups

RC Groups
    Electric Plane Talk
        Question Does Easystar Elevator Section Need to be Glued on?

#1 easystarfpv4 Mar 28, 2012 05:29 AM

Does Easystar Elevator Section Need to be Glued on?
 
As I was putting my easystar together, I noticed that the Elevator section came with a ready to stick on surface, but after sticking it on the base of the fuselage, it just doesn't have a solid feeling of being stuck to the fuselage. Was wondering what others may have done when putting their kit together? Was thinking of putting some glue there to ensure that the part doesn't separate during flight. Any tips to what others may have done would be highly appreciated.

#2 Lancer31 Mar 28, 2012 06:00 AM

Check the instructions
 
Instruction 6, in my manual says to make sure everything is lined up straight & true, and then to glue it with Cyanoacrylate cement. They recommend using an accelerator with the cya. Good luck with your EZ*!

#3 rcshirt Mar 28, 2012 10:13 AM

if in doubt, i would glue it. even some planes that bolt on the tail that are arfs should be glued... thinking nexstars...

#4 Pete Miller Mar 28, 2012 10:38 AM

http://www.rcgroups.com/forums/showthread.php?t=1564626


All times are GMT -5. The time now is 02:21 AM.